Country Clipper Zeton Especificações

P-11527 (2004) Safety Instructions & Operators Manual COUNTRY CLIPPER Congratulations for buying a Country Clipper product. Your

MOWING RECOMMENDATIONS 1. Keep mower blades sharp. 2. Make sure deck and discharge are clean. CAUTION POWER MUST BE OFF TO CLEAN DIS

MAINTENANCE CAUTION BEFORE PERFORMING ANY MAINTENANCE, TURN OFF ENGINE REMOVE KEY AND DISCONNECT SPARK PLUGS. USE EXTREME CARE WHEN

MAINTENANCE INSTRUCTIONS 1. ENGINE: For complete maintenance and operating information for your engine, please refer to your engine operating and

D. Check balance of blade by positioning the blade on a nail or blade balance pedestal. Grind the blade on the end that is heavier until both sid

TWINSTICK STEERING CONTROL ADJUSTMENT 8. To Adjust Neutral: a. Remove the fender skirts from each side of the machine. b. Block up the unit

12. JOYSTICK CONTROL LEVER NEUTRAL ADJUSTMENT: With the engine running, if the machine travels in either direction when the Joystick Cont

B. Stop the machine and shut of the engine. C. Slightly loosen the bolt at the lower end of the upper linkage assembly on the side that is slower.

PROCEDURE FOR RAISING AND LOWERING THE DECK FOR SERVICING 14. RAISING THE DECK: A. Remove cut height adjustment pin and completely lower the cut

16. LEVELING THE DECK: A. Set the tire pressure on all four tires B. Move the tractor to a hard, level surface (i.e. concrete or blacktop). P

ASSEMBLY / OPERATION SHEET DECK FLIP JACK 1. Turn off lawn mower and set brakes. Remove cut/height adjust pin and lower deck lift handle to lowest p

WARRANTY INFORMATION SERIAL NUMBER ____________________________________________________________________ DATE PURCHASED_______________________

TROUBLE SHOOTING CHECK LIST 1. ENGINE WON’T TURN OVER: Mower blades engaged ------------------------------------------------- disengage blades

6. ENGINE SOMETIMES SKIPS AT HIGHER SPEEDS: Incorrect Ignition Timing ---------------------------------------------------- consult dealer Carb

WIRING SCHEMATIC: FOR JOYSTICK MODEL START SWITCH POSITION CIRCUIT “MAKEOFF G+M ON B+L START

WIRING SCHEMATIC: FOR TWINSTICK MODEL NOTE: ALL WIRE CONNECTORS SHOWN AT WIRE SIDE Black wires = Ground Red wires = Power Blue wires = Kill Ci

WIRING SCHEMATIC: FOR E.F.I. JOYSTICK MODEL START SWITCH POSITION CIRCUIT “MAKEOFF G+M ON B+L START

WIRING SCHEMATIC: FOR E.F.I. TWINSTICK MODEL START SWITCH POSITION CIRCUIT “MAKEOFF G+M ON B+L START

TABLE OF CONTENTS I. OWNER INFORMATION Warranty Information ----------------------------------------------------------- 2 II. SAFETY Ac

SAFETY ACCIDENT PATTERNS TO AVOID I. CONTACT WITH THE ROTATING BLADE -- This accident usually happens when the operator is clearing the

7. DO NOT MOVE CONTROL LEVER(S) from forward position to reverse position rapidly. The speed and/or direction of travel is affected instantly by mo

25. MOW ONLY DURING DAYLIGHT. 26. THIS MACHINE IS NOT MEANT FOR HIGHWAY OR STREET USE. It is not a recreational vehicle and it should not be oper

JOYSTICK STEERING INFORMATION 12. Clean the air intake screen on the engine if necessary. 13. Perform any other maintenance as it becomes necessary

TWINSTICK STEERING INFORMATION 12. Clean the air intake screen on the engine if necessary. 13. Perform any other maintenance as it becomes necessar

CAUTION FOR SMOOTH, SAFE OPERATION, MOVE THE CONTROL LEVER(S) IN A GENTLE, SLOW MOTION. NEVER PULL OR PUSH THE CONTROL LEVER(S) RAPIDLY